Home > Components > Deep Impact Components >

Black Eagle Black Outsert Deep Impact
Black Eagle Arrows Outserts


 
Our Price: $20.99

:
: Usually Ships in 24 to 48 Hours


Deep Impact Outserts:
  

Qty:
Description
 
These black anodized 7075 T6 aluminum alloy outserts have been tested and designed by experienced hunters and target archers to ensure maximum penetration and performance. The Deep Impact Outsert fully encompasses the base of the shaft just over 1 inch providing OUTSTANDING arrow strength and concentricity. With Micro-Glue channels inside the outsert to create a much better bonding surface this outsert is built to last shot after shot. If you are looking for maximum penetration and shot after shot performance then the deadly combination of the Deep Impact Outsert and shaft are sure to be a hit!
The Deep Impact Outsert Weights are a Follows:
  • 250 Spine = 42 Grains
    300 Spine = 40 Grains
    350 Spine = 42 Grains
    400 Spine = 42 Grains
    500 Spine = 44 Grains
    600 Spine = 46 Grains

To install the outsert.
  1. Select the right outsert for the right shaft.
  2. Dry fitting is recommended on all components. Slide Outserts over shaft and spin test (if you prefer)
  3. If Outserts does not fit that is OK. Get some 100 Grit sand paper and lightly sand the shaft in a circular motion until the outsert fits snug on shaft. Start slowly so you don't remove to much off the arrow.
  4. Wipe dust off of the shaft with Clean paper towel. (No Cleaners are recommended)
  5. Again, Spin test to ensure concentricity. Rotating outsert until it spins perfect.
  6. Use a Silver or Black Sharpie and mark the Shaft and the Outsert for perfect alignment once glue is applied.
  7. We have tested Our fletching glue, insert/outsert glue and epoxy and all of them work great.
  8. Apply a even amount of glue around the shaft to ensure the glue channels get enough glue in them to hold.
  9. Once The outsert is glued on stand the arrow on the nock end to dry.

Average Rating: 5 of 5 Total Reviews: 4 Write a review »

  0 of 0 people found the following review helpful:
 
Triple check April 15, 2017
Reviewer: Bear Hause from Covington, WA United States  
I am very impressed with the performance of the deep impact arrows. I build my own and I will warn, be very careful prepping the outserts prior to glueing them on. I had to sand some of the shafts and even then, two did not want to go in all the way. I caught it soon enough to use pliers to rip the outsert off before losing the entire shaft. Yes, it ruined the outsert but I'd prefer that then losing a shaft. I would still highly recommend these shafts!

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
Deep Impact OutSert April 3, 2017
Reviewer: robert evans from frederick, MD United States  
very accurate.... need to be able to add weights

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
Deep impacts March 7, 2017
Reviewer: Troy owens from Boulder, WY United States  
Seem really tough

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
Why I chose black eagle over easton November 23, 2016
Reviewer: jake . from port colborne, ON Canada  
No more chasing and paying for deepsix field points and broadheads! Weighted for foc weight! Tapers to your standard 5/16" field point & broadhead diameter! No brainer!

Was this review helpful to you?